What happens to the landing gear of Ji'nan road brake?
1, power-off protection switch: control part of the power brake failure, automatic protection device gate will automatically work, the brake lever to stop position does not move on the ramp, the total power is disconnected, the machine does not work. At this time, the door will be opened, the large belt clockwise rotation, 3-8 laps to the upper can be restored. If so many times can not be restored, you need to check whether the Holzer components and circuit boards are out of order.
2, road brake live screws loose: live joint screws for positive and negative thread connection, the upper and lower two bearings with double headed screw connection, if the screw loose, will cause the upper and lower is not accurate. With a length of 80MM with diameter of 4 bar into the double screw rotating between the brake lever on the place can be adjusted.
3, the gate of the crank arm screw loose: if the screws are loose, will cause the brake bar gate the inaccuracies and stop when a large rock, the bolt hanging tight, tighten the nut.
4, the drop hook adjustment nut is loose: the lower part of the case is equipped with a screw M10 pull down hook, and its function is to pull the balance mechanism of the spring and balance function of zero adjustment.
5, place control magnet move position: upper and lower positions are adopted Tzu sensitive Holzer components, if the rectangular magnet and reducer with cam disk position change, resulting in inaccurate。 Adjust it accurately, and can not flip, you can solve the problem。
6, gate coil catgut embedding loose: local sense coil can not be firmly fixed in the nest, the car off the road vibrations will cause the deformation of the coil inside the nest, sense of change in the initial inductance, the sensor must be reset back to work properly. The solution is to pour the melted asphalt into it and secure it.